OSHA: No component of this product present at levels greater than or equal to 0.1% is identified as a carcinogen or potential carcinogen by OSHA.Reproductive toxicityĮffects on Newborn: Growth statistics (e.g., reduced weight gain). NTP: No component of this product present at levels greater than or equal to 0.1% is identified as a known or anticipated carcinogen by NTP. IARC: No component of this product present at levels greater than or equal to 0.1% is identified as probable, possible or confirmed human carcinogen by IARC.ĪCGIH: No component of this product present at levels greater than or equal to 0.1% is identified as a carcinogen or potential carcinogen by ACGIH. Other decomposition products - No data availableġ1.1 Information on toxicological effects Stable under recommended storage conditions. Surface tension 72.8 mN/m at 1 at 20 ☌ (68 ☏) T) Oxidizing properties: No data available S) Explosive properties: No data available Q) Decomposition temperature: No data available COMPOSITION/INFORMATION ON INGREDIENTSĬomponent / Classification / ConcentrationĬaesium chloride / Acute Tox. P501 Dispose of contents/ container to an approved waste disposal plant.Ģ.3 Hazards not otherwise classified (HNOC) or not covered by GHS - none P308 + P313 IF exposed or concerned: Get medical advice/ attention. P301 + P312 + P330 IF SWALLOWED: Call a POISON CENTER or doctor/ physician if you feel unwell. P280 Wear protective gloves/ protective clothing/ eye protection/ face protection. P270 Do not eat, drink or smoke when using this product. P264 Wash skin thoroughly after handling. P260 Do not breathe dust/ fume/ gas/ mist/ Vapors/ spray. P202 Do not handle until all safety precautions have been read and understood. ![]() ![]() P201 Obtain special instructions before use. H373 May cause damage to organs through prolonged or repeated exposure. H361 Suspected of damaging fertility or the unborn child. Thin Film Deposition & Evaporation Materials.Additive Manufacturing & 3D Printing Materials.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |